rus
Issue #1/2024
P. A. Petrov, I. A. Burlakov, P. A. Polshkov, M. A. Chibizov, B. Yu. Saprykin
Study of A Method for Increasing the Strength of PLA Filament
Study of A Method for Increasing the Strength of PLA Filament
DOI: 10.22184/2499-9407.2024.34.1.60.63
The results of comparative analysis of strength characteristics of blanks obtained by 3D printing from ESUN PLA filament, which were subjected to tempering at different temperatures, are presented.
Tags: 3d printing 3d-печать compression and tensile test pla filament strength tempering испытание на сжатие и растяжение отпуск прочность филамент pla
Subscribe to the journal Stankoinstrument to read the full article.
The results of comparative analysis of strength characteristics of blanks obtained by 3D printing from ESUN PLA filament, which were subjected to tempering at different temperatures, are presented.
Tags: 3d printing 3d-печать compression and tensile test pla filament strength tempering испытание на сжатие и растяжение отпуск прочность филамент pla
Subscribe to the journal Stankoinstrument to read the full article.
Readers feedback
